The analysis of sea-ice cores from three summer field operations to the European Arctic is reported, and the ice properties are related to general conditions of ice distribution, thickness, and ridging in the experimental areas. The operations were in 1978 and 1979 to the Kong Oscars Fjord area of East Greenland (about lat. 72° N.) and in 1980 to the Barents Sea, Fram Strait, and the Arctic Ocean north of Svalbard and Zemlya Frantsa Iosifa on the Swedish Ymer-80 expedition. Salinity profiles show the effect on multi-year floes of a year’s additional confinement in a fjord, the effect of a month’s desalination (July to August) on first-year and multi-year ice, and the difference between first-year and multi-year ice at the end of the melt season. The average salinity as a function of ice thickness agrees reasonably well with the results of Cox and Weeks (1974). Temperature, density, pH, and ionic composition results are also reported, and the effect of brine volume on dielectric constant discussed.

Specimens of polar snow from the South Pole, Antarctica, were tested to investigate air permeability K (cm.sec.−1), ultimate compressive strength σc (g.cm.−2) and dynamic Young’s modulus E (g.cm.−2) as a function of density. Anisotropy in a single layer of snow (snow between two summer crusts) was found in all three properties. Comparison with data for snow from Site 2, Greenland showed an empirical relation for both areas:

Air permeabilities are different at the two sites because of time and meteorological effects.

Recent regional cooling has impacted the natural systems of the Antarctic Peninsula (AP); however, little is known concerning the changes in the high parts of the glacial systems. Dry-snow line (DSL), situated in the high parts of glaciers, is the uppermost limit of frequent or occasional surface melt. We analyse dry-snow line altitude (DSLA) changes on the AP during 2004–2020 using C-band synthetic aperture radar time series data. We demonstrate that the DSLA in the eastern part of the AP is usually higher than that of the western part. Moreover, using simulated climatic variables from regional climate models, the lowering in altitude of DSL of glaciers in most areas is identified as a response to a decrease in snowmelt and an increase in precipitation. Furthermore, correlation analyses between simulated climatic variables and the DSLA are conducted. These results present the sensitive response of variations in DSLA to meteorological conditions, and the capability of DSLA being a proxy of polar local climate in high-altitude areas with no in situ meteorological observations.

Observations and measurements were made of high-speed avalanches at Shiai-dani, the Kurobe canyon, to reveal their real features and properties, using strain-gauge-type load cells in measuring impact force and speed. A maximum impact pressure of 140 - 104 N m-2 was obtained, as well as data indicating the existence of a number of wave fronts, ranging in speed from 9 to 60 m s -1 inside an avalanche. Violent changes in atmospheric pressure ranging from -21 to +5 mbar were observed near its path when a high-speed avalanche passed by.

Ice shelves, which regulate ice flow from the Antarctic ice sheet towards the ocean, are shaped by spatiotemporal patterns of surface accumulation, surface/basal melt and ice dynamics. Therefore, an ice dynamic and accumulation history are imprinted in the internal ice stratigraphy, which can be imaged by radar in the form of internal reflection horizons (IRHs). Here, IRHs were derived from radar data combined across radar platforms (airborne and ground-based) in coastal eastern Dronning Maud Land (East Antarctica), comprising three ice rises and adjacent two ice shelves. To facilitate interpretation of dominant spatiotemporal patterns of processes shaping the local IRH geometry, traced IRHs are classified into three different types (laterally continuous, discontinuous or absent/IRH-free). Near-surface laterally continuous IRHs reveal local accumulation patterns, reflecting the mean easterly wind direction, and correlate with surface slopes. Areas of current and past increased ice flow and internal deformation are marked by discontinuous or IRH-free zones, and can inform about paleo ice-stream dynamics. The established IRH datasets extend continent-wide mapping efforts of IRHs to an important and climatically sensitive ice marginal region of Antarctica and are ready for integration into ice-flow models to improve predictions of Antarctic ice drainage.

Field investigations of supraglacial debris were carried out during the monsoon season in 1974 on G2 glacier near Tukche Peak in Hidden Valley, Mukut Himal, Nepal. The thickness of the debris layer was observed to increase down-glacier. Laboratory analysis, however, showed a decrease in particle size in the same direction. This decrease is explained in terms of mixing of particles contained in glacier ice with the original debris as melting proceeds. A simple relation between debris mass and glacier flow is introduced to explain the observed results.

Dielectric experiments have been undertaken at temperatures between −2° and −70° C in the frequency range 10Hz to 100 kHz on 14 firn and ice samples retrieved from the Antarctic Peninsula. This investigation shows that the dielectric behaviour of polar samples from the Antarctic Peninsula is very similar to that of polar firn and ice from Greenland and from elsewhere in Antarctica. In contrast, temperate samples from the Antarctic Peninsula have relaxation times up to ten times shorter for a given temperature between –20° and –70°C, and have higher values of high-frequency conductivity than those of polar samples. Consequently, the thermal regime (temperate or polar) can be distinguished by the dielectric behaviour of the samples.

High-frequency conductivities of polycrystalline samples from the Antarctic Peninsula match the trends of published conductivity data for HF- and HCl-doped laboratory ice; higher conductivities are associated with coastal sites where greater concentrations of marine ions occur in snow.

Annealing polar firn above −10°C results in elevated conductivities across all frequencies measured and shortened relaxation times. Thus, samples for dielectric analysis should not be warmed to above –10°C for risk of irreversibly altering their dielectric behaviour.

In ice-fabric studies, use of an accessory plate is necessary in conjunction with the Rigsby universal stage to discriminate between the a- and c-axes of an ice crystal when the orientation of the c-axis is parallel or nearly parallel to the stage. The techniques described permit orientation of the c-axis regardless of its orientation.

The cutting force components and the cutting moment on the cutting tool were measured during the orthogonal machining of ice with cutting tools inclined at negative rake angles. The variables included the cutting depth (< 1 mm), the cutting speed (0.01 ms−1 to 1 ms−1), and the rake angles (–15° to –60°). Results of the experiments showed that the cutting force components were approximately independent of cutting speed. The resultant cutting force on the tool was in a direction approximately normal to the cutting face of the tool. The magnitude of the resultant force increased with the negative rake angle. Photographs of ice-chip formation revealed continuous and segmented chips at different cutting depths.

The first extensive and far-reaching investigations of the Sino-German Joint Expedition to the Ch’ing-hai–Hsi-tsang (Qinghai–Xizang) Plateau in the glacierized region of the Amne Machin (Anyemaqen) started work in the area and compiled the glacial inventory in that region. In the past 15 years scientists have found that the majority of glaciers in the Amne Machin (Anyemaqen) have been advancing whereas most glaciers in Ch’i-lien Shan (Qilian Shan), adjacent to Amne Machin (Anyemaqen), have been retreating during the same period. This is a problem worthy of study by glaciologists. Through investigation and analysis, it is also found that Ha-lung (Halong) glacier has the character of a surging glacier. The author tentatively forecasts the next surge of Ha-lung (Halong) glacier and the tendency of variations of glaciers in Ch’i-lien Shan (Qilian Shan) in the near future.

Modes of formation and rates of collapse have been determined for kame terraces and a fan delta in the Adams Inlet area, Alaska. The hummocky and trenched surface of the kame terrace develops by mass-wasting processes caused by differential melting of buried ice. The dry channels in the collapsed part of the terrace are formed by melt water during stagnant-ice bursts. Measurements over a period of 17 years indicate that terrace back-wasting averages 4.3 m a−1. The fan delta is forming near sea-level by streams that derive part of their load from the kame terrace. The fan delta seaward of the retreating kame terrace is undergoing partial collapse to produce kettles ringed by concentric fractures. Vegetation, now as much as 5 m below high tide, suggests a fan-delta collapse rate of about 0.5 m a−1.

Measurements of mesoscale sea-ice deformation over a region approximately 20 km in diameter were carried out over a five-week period in the spring of 1972 at the main AIDJEX camp in the Beaufort Sea. They have been analyzed to determine non-linearities in the ice velocity field (due to the discrete small-scale nature of the ice pack), as well as a continuum mode of deformation represented by a least-squares strain-rate tensor and vorticity. The deformation-rate time series between Julian day 88 and 112 exhibited net areal changes as large as 3% and deformation rates up to 0.16% per hour. In the principal axis co-ordinate system, the strain-rate typically exhibited a much larger compression (or extension) along one axis than along the other. Persistent cycles at ≈ 12 h wavelengths were observed in the divergence rate.

A comparison of the average residual error with the average strain-rate magnitude indicated that strains measured on a scale of 10 km or greater can serve as a valid measure of the continuum motion of the sea ice. This conclusion is also substantiated by a comparison between the mesoscale deformation, and macroscale deformation measured over a ≈ 100 km diameter region.

Regarding pack-ice rotation, vorticity calculations indicate that at low temporal frequencies (0.02 h−1), the whole mesoscale array rotates essentially as an entity and consequently the low-frequency vorticity can be estimated accurately from the rotation of a single floe.

It is well known that ice-cube spikes form by the extrusion of water at the surface of a freezing ice cube, driven by the expansion accompanying freezing. The growing spikes are water-filled ice tubes, growing at their tips as the water is expelled. This paper represents an exploration of their formation and the principles behind whether a freezing ice cube grows a spike or not. For this purpose, ice cubes are frozen in one set of conditions to observe what happens when spikes do or do not form. Spike formation requires a nearly steady-state freezing-and-extrusion process at the growing tip, in order to maintain a nearly constant diameter. Most spikes are polycrystals with special orientation relationships that evidently allow the steady state to become established. Thus the orientations of the initial crystals, formed by chance, help to determine whether a spike forms or not. The main alternative to spike formation is flooding over the upper surface of the ice. Spike formation depends upon an effectively non-zero contact angle of water on ice that impedes flooding. The onset of flooding is probably sensitive to the ice growth rate at the water surface, which depends strongly upon the crystal orientation with respect to the water surface where it contacts the crystal.

The concentration of microparticles in the 2 164 m long ice core from “Byrd” station Antarctica, varies cyclically. Highest concentrations of 0.65 μm diameter microparticles occur where oxygen-isotope studies show lowest paleotemperatures. The age of the bottom ice estimated from microparticle-concentration variations, assuming an annual cycle, is 27 000 years, much less than from oxygen-isotope studies.

Results obtained from tensile and compressive tests on pure ice single crystals at various temperatures down to −90°C are reported. At −50°C tensile creep tests give a continually increasing creep rate until fracture, as observed at higher temperatures. The stress dependence of the strain-rate is discussed. Fracture stress increases with decreasing temperature. Results from constant strain-rate compressive tests are compared with theoretical curves computed from Johnston’s (1962) theory of dislocation multiplication. A dislocation velocity of the order of 0.5×10−8 m s−1 is deduced for ice at −50°C.

The dynamics of seasonal snow ablation on six glaciers in central Spitsbergen (Dicksonland) were assessed by examining a set of Sentinel-2 satellite images covering the summer ablation season for the period 2016–19. All glaciers lost 80% or more of their surface snow cover during the studied ablation seasons. This bolsters the recently observed trend of local glacier thinning, even at higher altitudes. Snow ablation dynamics are highly dependent on the glaciers altitudes, their position relative to the prevailing wind direction and the exposure to insolation. The accumulation areas of the studied glaciers were delimited based on the overlap of the minimum extent of snow-covered areas in the four consecutive studied summer seasons. The high temporal and spatial resolutions of available images enabled a detailed description of the seasonal snow ablation dynamics. Moreover, an estimate of the average number of days with below threshold glacier snow cover was made. This study contributes to our understanding of recent processes and might further support the modelling of glacier melt and subsequent runoff.

Observations were carried out on each significant layer of the snow cover at Ottawa (lat. 45° 24′ N., long. 75° 43′ W.) on the thickness of the layer, and the density, grain size distribution and degree of bonding of the snow in each layer. A logarithmic dependence on time was found for the layer thickness, and the density and grain size distribution. The product of layer thickness times the corresponding snow density was found to be constant when no melting occurred.

A correlation between temperature gradient in snow–pack and material strength is found to exist in laboratory studies on temperature gradient metamorphism of snow. These results are in agreement with earlier field investigations and eliminate diurnal solar and temperature variations as reasons for the existence of the maximum temperature gradient in the zone of minimum strength. Also the laboratory studies have indicated that locally dense layers such as ice crusts tend to enhance weakness directly below the crust due to local alteration of the thermal regimen. Further studies are continuing to describe the thermodynamic process of temperature gradient metamorphism more exactly.

Results of ten-year measurements of avalanche impact upon a large-sized installation are shown. The installation is equipped with 20 pressure sensors using the principle of the intrusion of a steel cone into a duralumin plate. The impacts of 30 dry avalanches with volumes from 100 up to 50 000 m3 are analysed. A maximum pressure at “a point" of 1 100 kN/m2 and a pressure of 650 kN/m3 averaged over the area of the installation (24 m2) were recorded. It is found that 75% of the impact energy is concentrated in the lowest 2 m of the installation. Proceeding from these data, and also taking into account that the thickness of an avalanche body amounts to 10-20 m at the moment of impact, we may conclude, that there is a “dense core" and an upper ’"high aerosol" part in an avalanche body.

The use of slereo-photogrammetric surveys of moving avalanches revealed the “velocity depression" effect in the Khibin avalanches: Avalanche velocity decreases abruptly (by a factor 1.5 to 2) at the end of transit channel and then grows rapidly up to a maximum at the end of the avalanche cone. The greatest variations of velocity amount to 51 m/s.

The data obtained prove the inefficiency of anti-avalanche filling dams, especially because of their negative role in the generation of disasterous air waves, whose pressure varies from 20 up to 150 kN/m 2.