Hostname: page-component-6bf8c574d5-7jkgd Total loading time: 0 Render date: 2025-02-14T22:50:37.084Z Has data issue: false hasContentIssue false
  • English
  • Français

Heat Transfer in Melt Spinning Cooling Belts and Drums

Published online by Cambridge University Press:  21 February 2011

B. W. Swanson ,
R. S. Williams  and
R. Draper
B. W. Swanson
Affiliation:
Westinghouse Electric Corporation, Research and Development Center, Pittsburgh, PA 15235
R. S. Williams
Affiliation:
Westinghouse Electric Corporation, Research and Development Center, Pittsburgh, PA 15235
R. Draper
Affiliation:
Westinghouse Electric Corporation, Research and Development Center, Pittsburgh, PA 15235
Get access

Abstract

Fourier series solutions have been obtained for the temperature distributions in melt spinning cooling belts and drums. These solutions have been used to determine drum and belt designs for producing 0.050 inch steel sheet. This paper discusses thermal design parameters for cooling drums used in melt spinning rapid solidification.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 28: Symposium F – Rapidly Solidified Metastable Materials , 1983 , 113
Copyright
Copyright © Materials Research Society 1984

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Kuiken, H. K., Int. J. Heat Mass Transfer 20, p. 309 (1977).10.1016/0017-9310(77)90151-XGoogle Scholar
2. Katto, Y. and Kunihiro, M., Bulletin of JSME 16, No. 99, p. 1357–1366 (1973).10.1299/jsme1958.16.1357Google Scholar
3. Monde, M. and Katto, Y., Int. J. Heat Mass Transfer 21, p. 295–305 (1978).10.1016/0017-9310(78)90122-9Google Scholar
4. Katto, Y. and Ishii, K., Sixth International Heat Transfer Conference, 1, Toronto, p. 335–440 (1978).Google Scholar
5. Nakanishi, S. and Ochi, T., Sixth International Heat Transfer Conference, 1 Toronto, p. 445–450 (1978)Google Scholar
6. Miller, R. S., Metallurgical Trans. B 14B, p. 71–76 (1983).10.1007/BF02670871Google Scholar
7. Easoz, J. R. and Nahemow, M. D., Proc. 9th Symp. on Engineering Problems of Fusion Research 2, p. 1670–1673 (1981). (Details through private communication).Google Scholar