Hostname: page-component-6bf8c574d5-7jkgd Total loading time: 0 Render date: 2025-02-15T09:59:06.311Z Has data issue: false hasContentIssue false
  • English
  • Français

Direct Writing of 3D Microstructures Using a Scanning Laser System

Published online by Cambridge University Press:  01 February 2011

Hui Yu ,
Alexander Grüntzig ,
Yi Zhao ,
André Sharon ,
Biao Li  and
Xin Zhang
Hui Yu
Affiliation:
Department of Manufacturing Engineering and Fraunhofer USA Center for Manufacturing Innovation, Boston University, Boston, MA 02215, USA
Alexander Grüntzig
Affiliation:
Department of Manufacturing Engineering and Fraunhofer USA Center for Manufacturing Innovation, Boston University, Boston, MA 02215, USA
Yi Zhao
Affiliation:
Department of Manufacturing Engineering and Fraunhofer USA Center for Manufacturing Innovation, Boston University, Boston, MA 02215, USA
André Sharon
Affiliation:
Department of Manufacturing Engineering and Fraunhofer USA Center for Manufacturing Innovation, Boston University, Boston, MA 02215, USA
Biao Li
Affiliation:
Department of Manufacturing Engineering and Fraunhofer USA Center for Manufacturing Innovation, Boston University, Boston, MA 02215, USA
Xin Zhang
Affiliation:
Department of Manufacturing Engineering and Fraunhofer USA Center for Manufacturing Innovation, Boston University, Boston, MA 02215, USA
Get access

Abstract

In this paper, a new revolutionary 3D manufacturing approach to rapid processing of 3D microstructures in both soft (SU-8) and rigid (Si) materials is introduced. This technique facilitates very fast prototyping without the need of masks, resulting in a low-cost, short-turnaround flexible fabrication process.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 782: Symposium A – Micro- and Nanosystems , 2003 , A11.5
Copyright
Copyright © Materials Research Society 2004

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Han, M., Lee, W., Lee, S. and Lee, S.S., Proceedings of μTA S, 106 (2002).Google Scholar
2. Jackman, R.J., Floyd, T.M., Ghodssi, R., Schmidt, M.A. and Jensen, K.F., J. Micromech. Microeng. 11, 1 (2001).Google Scholar
3. Chuang, Y., Tseng, F., Cheng, J. and Lin, W., Sensors and Actuators A103, 64 (2003).Google Scholar
4. Seidemann, V., Butefisch, S. and Buttgenbach, S., Sensors and Actuators A97–98, 457 (2002).Google Scholar
5. Tay, F.E.H., Kan, J.A.V., Watt, F., Choong, W.O., J. Micromech. Microeng. 11, 27 (2000).Google Scholar
6. Bäuerle, Dieter, Laser Processing and Chemistry, Springer (2000).Google Scholar