Hostname: page-component-6bf8c574d5-b4m5d Total loading time: 0 Render date: 2025-02-15T09:03:42.056Z Has data issue: false hasContentIssue false
  • English
  • Français

Burner Rig Thermal Fatigue Failure of SiC Continuous Fiber/Si3N4 Ceramic Composites

Published online by Cambridge University Press:  15 February 2011

T. Ertürk ,
K. Park  and
C. Sung
T. Ertürk
Affiliation:
Department of Chemical and Nuclear Engineering, and University of Massachusetts, Lowell, MA 01854
K. Park
Affiliation:
Center for Advanced MaterialsUniversity of Massachusetts, Lowell, MA 01854
C. Sung
Affiliation:
Center for Advanced MaterialsUniversity of Massachusetts, Lowell, MA 01854
Get access

Abstract

The burner rig thermal fatigue properties of SiC continuous fiber/Si3N4 ceramic composites were examined under impinged jet fuel flame, a constant applied tensile stress and thermal cycling in the temperature range 500-1350 °C. The SCS-9 SiC fiber/Si3N4 composites failed within the flame impinged zone, whereas the SCS-6 fiber/Si3N4 composites failed outside the flame impinged zone due to the high thermal stresses resulting from high-temperature gradients. Analytical transmission electron microscopy was used to investigate the microstructure and chemistry of the fiber, matrix and fiber/matrix interface in the failed SCS-9 SiC fiber/Si3N4 composites. The partial degradation of columnar structure of the fiber was interpreted as the dominant mechanism of burner rig thermal fatigue failure of SCS-9 SiC fiber/Si3N4 composites.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 365: Symposium M – Ceramic Matrix Composites–Advanced High-Temperature Structural Materials , 1994 , 449
Copyright
Copyright © Materials Research Society 1995

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

[1] Zawada, L. and Wetherhold, R., J. Mater. Sci. 26 654 (1991).Google Scholar
[2] Butkus, L. M., Holmes, J. W. and Nicholas, T., J. Am. Ceram. Soc., 76, 2817 (1993).Google Scholar
[3] Worthem, D. W. and Ellis, J. R., Ceram. Eng. Sci. Proc., 14, 292 (1993).Google Scholar
[4] Erturk, T., “Burner Rig Thermal Fatigue Response of Hot Pressed Continuous Fiber Ceramic Composites”, in Transition to Practice Technologies for Advanced Ceramics and Brittle Matrix Composites, (1994) Generazio, E. R. (Ed,), Technomic Publishing, in press.Google Scholar
[5] Yang, J-M., Chen, S. T. J., Jeng, S. M. and Thajer, R. B., J. Mater. Res., 6, 1926 (1991).Google Scholar
[6] Bhatt, R. T. and Hull, D. R., Ceram. Eng. Sci. Proc., 12, 1832 (1991).Google Scholar