Hostname: page-component-6bf8c574d5-qdpjg Total loading time: 0 Render date: 2025-02-15T09:55:39.632Z Has data issue: false hasContentIssue false
  • English
  • Français

Characterization of Melt Spun Cu-Nb Ribbons

Published online by Cambridge University Press:  15 February 2011

Mei Ling Henne  and
Fereshteh Ebrahimi
Mei Ling Henne
Affiliation:
Materials Science and Engineering DepartmentUniversity of Florida, Gainesville, FL 32611
Fereshteh Ebrahimi
Affiliation:
Materials Science and Engineering DepartmentUniversity of Florida, Gainesville, FL 32611
Get access

Abstract

Microstructure of rapidly solidified Cu-5wt%Nb ribbons produced by melt spinning was investigated by SEM and TEM techniques. Two heat treatments were done: 960°C 1 hour and 900° 3 hours. The microstructures contained three different type particles: (a)large particles located at the grain boundary, (b)small spherical particles located within the grains and at the grain boundaries, and (c)fine precipitates formed upon heat treatment. The evolution of the microstructure is discussed with regard to the previously reported studies.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 362: Symposium J – Grain-Size and Mechanical Properties--Fundamentals and Applications , 1994 , 211
Copyright
Copyright © Materials Research Society 1995

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Spitzig, W.A., Pelton, A.R., Laabs, F.C., Act metall, 35, 2427(1987)Google Scholar
2. Zeik, K.L., Koss, D.A., Anderson, I.E., and Howell, P.R., Metallurgical Transactions A. 23A. 2159(1992).Google Scholar
3. Cooper, K.P., Ayers, J.D., Kampe, J.C. Malzahn, Feng, C.R., and Locci, I.E.. Mater. Sci. Eng. A142, 221(1991).Google Scholar