Hostname: page-component-6bf8c574d5-2jptb Total loading time: 0 Render date: 2025-02-23T07:45:59.021Z Has data issue: false hasContentIssue false

Three-dimensional acoustic-roughness receptivity of a boundary layer on an airfoil: experiment and direct numerical simulations

Published online by Cambridge University Press:  17 March 2003

W. WÜRZ
Affiliation:
Institut für Aerodynamik und Gasdynamik, Universität Stuttgart, Pfaffenwaldring 21, 70550 Stuttgart, Germany
S. HERR
Affiliation:
Institut für Aerodynamik und Gasdynamik, Universität Stuttgart, Pfaffenwaldring 21, 70550 Stuttgart, Germany
A. WÖRNER
Affiliation:
Institut für Aerodynamik und Gasdynamik, Universität Stuttgart, Pfaffenwaldring 21, 70550 Stuttgart, Germany
U. RIST
Affiliation:
Institut für Aerodynamik und Gasdynamik, Universität Stuttgart, Pfaffenwaldring 21, 70550 Stuttgart, Germany
S. WAGNER
Affiliation:
Institut für Aerodynamik und Gasdynamik, Universität Stuttgart, Pfaffenwaldring 21, 70550 Stuttgart, Germany
Y. S. KACHANOV
Affiliation:
Institute of Theoretical and Applied Mechanics, Institutskaya str. 4/1, Novosibirsk, 630090, Russia
Rights & Permissions [Opens in a new window]

Abstract

Core share and HTML view are not available for this content. However, as you have access to this content, a full PDF is available via the ‘Save PDF’ action button.

The paper is devoted to an experimental and numerical investigation of the problem of excitation of three-dimensional Tollmien–Schlichting (TS) waves in a boundary layer on an airfoil owing to scattering of an acoustic wave on localized microscopic surface non-uniformities. The experiments were performed at controlled disturbance conditions on a symmetric airfoil section at zero angle of attack. In each set of measurements, the acoustic wave had a fixed frequency fac, in the range of unstable TS-waves. The three-dimensional surface non-uniformity was positioned close to the neutral stability point at branch I for the two-dimensional perturbations. To avoid experimental difficulties in the distinction of the hot-wire signals measured at the same (acoustic) frequency but having a different physical nature, the surface roughness was simulated by a quasi-stationary surface non-uniformity (a vibrator) oscillating with a low frequency fv. This led to the generation of TS-wavetrains at combination frequencies f1,2=facfv. The spatial behaviour of these wavetrains has been studied in detail for three different values of the acoustic frequency. The disturbances were decomposed into normal oblique TS-modes. The initial amplitudes and phases of these modes (i.e. at the position of the vibrator) were determined by means of an upstream extrapolation of the experimental data. The shape of the vibrator oscillations was measured by means of a laser triangulation device and mapped onto the Fourier space.

Type
Research Article
Copyright
© 2003 Cambridge University Press