Hostname: page-component-6bf8c574d5-9nwgx Total loading time: 0 Render date: 2025-02-16T00:44:20.296Z Has data issue: false hasContentIssue false
  • English
  • Français

Dimensions Required for Inspection

Published online by Cambridge University Press:  28 July 2016

Albert C. Parks
Albert C. Parks*
Affiliation:
The de Havilland Engine Co. Ltd.
Get access Rights & Permissions [Opens in a new window]

Extract

In his technical note on “Dimensions required for Inspection” (July Journal), Mr. G. A. G. Saywell stated that drawings calling up various machined fittings often lack any reference to “practical” measurement by which the operator, toolmaker and inspection department may “set out” and check the work concerned. This statement does not really do justice to the draughtsman who, in preparing the detail drawing for manufacture, has to give attention to all aspects of manufacturing.

Type
Technical Notes
Information
The Aeronautical Journal , Volume 57 , Issue 515 , November 1953 , pp. 725 - 728
Copyright
Copyright © Royal Aeronautical Society 1953

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Loxham, J. (1947). An Experiment in the Use of a Standard Limit System. Proceedings of Institution of Mechanical Engineers, Vol. 156, No. 2, 1947.Google Scholar
2. Gladman, G. A. (1945). Drawing Office Practice in Relation to Interchangeable Components. Proceedings of Institution of Mechanical Engineers, Vol. 152, 1945.Google Scholar